Festool LS 130 EQDUPLEX - Manual (Page 6)

6
Stirrer
Technical data
LS 130 EQ
Power 260 W
Speed (no load): 4,000 - 6.,00 rpm
Working strokes 8,000 - 12,000 rpm
Sanding stroke 4.0 mm
Sanding shoe 80 x 130 mm
Weight (excluding cable) 1.7 kg
Degree of protection / II
The specifi ed illustrations can be found at the be-
ginning of the operating instructions.
Symbols
Warning of general danger.
Read the Operating Instructions/Notes!
Wear protective goggles.
Wear a dust mask!
Wear ear protection!
1 Intended use
As specifi ed, the machines are designed for sand-
ing wood, plastic, metal, composite materials,
paint/varnish, fi ller and similar materials.
With the SSH-LS130_B100 scraper (accessory), you
can scrape off fl oor and wall coverings, residual
glue, etc.
Materials containing asbestos must not be pro-
cessed.
Thanks to its linear sanding movement, the LS 130
EQ is ideally suited for sanding battens, straight
profi les and in rebates.
For reasons of electrical safety the machine must
not be damp nor operated in a humid environment.
The machine may only be used for dry sanding.
The user is liable for damage and injury
resulting from incorrect usage!
2 Before starting up, please observe the
following
2.1 General Safety Rules
WARNING! Read all safety warnings and all
instructions. Failure to follow the warnings
and instructions may result in electric shock, fi re
and/or serious injury.
Save all warnings and instructions for future
reference.
The term „power tool“ in the warnings refers
to your mains-operated (corded) power tool or
battery-operated (cordless) power tool.
2.2 Tool-specifi c safety rules
Always wear protective goggles because
of possible dangers when sanding.
- The manufacturer’s handling and processing
instructions must be observed without fail if ex-
plosive or self-igniting dusts are likely to occur
during sanding.
- Harmful/toxic dusts can occur during your work
(e.g. lead-containing paint, some types of wood
and metal). Contact with these dusts, especially
inhaling them, can represent a hazard for operat-
ing personnel or persons in the vicinity. Comply
with the safety regulations that apply in your
country. Connect the electric power tool to a suit-
able extraction system.
To protect your health, wear a P2 protective
mask.
- Only for AS/NZS: The tool shall always be sup-
plied via residual current device with a rated
residual current of 30 mA or less.
2.3 Noise and vibration information
The typical values determined in accordance with
EN 60745 are:
Sound-pressure level
83 dB(A)
Sound-power level 94 dB(A)
Measuring uncertainty allowance K = 3 dB
Wear ear protection!
Overall vibration levels (vector sum for three di-
rections) measured in accordance with EN 60745:
Vibration emission level
(3 directions)
a
h
= 5.5 m/s 2
Uncertainty K = 2.0 m/s 2
The specifi ed emissions values (vibration, noise)
– are used to compare machines.
– They are also used for making preliminary
estimates regarding vibration and noise loads