Festool CTL 36 E-LE-AC CLEANTEX - Manual (Page 15)

CTL/ CTL AC CLEANTEX
15
GB
6 Operation
6.1 Initial operation
X Open the locking clips [2-2] and remove
the top section of the machine [2-1] .
X Remove the accessories from the dust
container
[2-3] and the packaging!
X Insert a filter or disposal bag in the dirt
trap (see chapter 7.6 and 7.7).
X Replace the top section [2-1] and close
the locking clips [2-2] .
X Attach the cable holder to the rear of the
mobile dust extractor (see Fig.
[3] ).
X Connect the suction hose to the machine.
6.2 Switch on/off
X Insert the plug into an earthed socket.
The switch [1-8] serves as an on/off switch.
Switch position "0"
Appliance socket
[1-3] is disconnected from
the power, mobile dust extractor is switched
off.
"MAN" switch position
Appliance socket
[1-3] is connected to the
power, the mobile dust extractor starts.
"Auto" switch position
Appliance socket
[1-3] is connected to the
power, the mobile dust extractor starts when
the connected tool is switched on.
7 Settings
7.1 Connecting electric power tools
X Connect the electric power tool to the ap-
pliance socket
[1-3] .
Following installation of the socket module
(included in the scope of delivery of the CTL
26 E SD), you can use the mobile dust ex-
tractor as follows:
– CTL 26 E SD E/A: Socket module with au-
tomatic switch-on function for the use of
two electric power tools: e.g. 2 sanders, 1
jigsaw + 1 sander
– CTL 26 E SD: Socket module with perma-
nent power supply for use as extension ca-
ble: e.g. charger, lamp, etc.
L The total power drawn, independently of
the socket type, must not exceed the
printed value.
7.2 Connecting pneumatic tools
If the compressed air module [1-2] (496141;
included in scope of delivery of CTL 36 E LE,
CTL 36 E LE AC) is installed, the automatic
switch-on function of the mobile dust extrac-
tor also works in combination with air tools.
We also recommend installing the VE service
unit (495886). The service unit filters and lu-
bricates the compressed air and enables an
adjustment of the air pressure. An IAS
adapter (454757) is available to connect Fes-
tool air tools to the IAS system.
The operating pressure of the tool must be 6
bar for the automatic switch-on unit to func-
tion correctly.
WARNING
Unauthorised voltage or frequency!
Risk of accident
X The mains voltage and the frequency of
the power source must correspond with
the specifications on the machine's name
plate.
X In North America, only Festool machines
with the voltage specifications 120 V/60
Hz may be used.
WARNING
Risk of injury from tools starting up un-
expectedly
X Before setting the switch to the "AUTO" or
"MAN" position, make sure that the con-
nected tool is switched off.
WARNING
Risk of injury
X Observe the maximum connected loads
for the appliance socket (see chapter
"Technical data").
X Make sure that the power tool is switched
off before connecting or disconnecting.
WARNING
Risk of injury
X Make sure that the pneumatic tool is
switched off before connecting or discon-
necting.