Festool CTM 48 E-LE-AC B22 CLEANTEX - Manual (Page 15)

CTM 48 E LE EC/B22, CTL 48 E LE EC/B22
15
GB
aged. Always replace the mains power
cable with the type specified in the spare
parts list.
– Do not expose the machine to rain.
– For reasons of safety, never operate the
machine from an unearthed socket.
– Always use the machine socket for the pur-
pose specified in the manual.
– Always use original Festool accessories.
– Pull the plug from the socket when the ma-
chine is not in use and prior to mainte-
nance and cleaning work.
– Design 22 dust extractors are suitable for
connecting to machines in Zone 22. Care
must be taken to ensure that no sources of
ignition are extracted. Conductive machine
components, including extractor hoods,
and conductive parts on machines from
protection class II must be electrostatically
earthed. The electrostatic earthing can be
routed through the dust extractor or estab-
lished using separate electrostatic earthing
equipment.
– Do not lift or transport the machine by the
handle using a crane or lifting gear.
– The device may only be operated if all fil-
ters are present and undamaged, including
the filter for the motor cooling air.
– Do not insert and remove the plug under
load.
– In an emergency (e.g. short circuit or other
electrical faults occur), switch off the ma-
chine and pull out the mains plug.
6 Operation
6.1 Initial operation
X
Open the locking clips [2-2] and remove
the top section of the machine [2-1] .
X
Remove the accessories from the dust
container [2-3] and the packaging!
X
Insert a filter bag in the dust container
that fulfils statutory requirements (see
chapter 7.8).
X
Replace the top section [2-1] and close
the locking clips [2-2] .
X
Attach the cable holder to the rear of the
mobile dust extractor (see Fig. [3] ).
X
Insert the sealing plug [1-1] on the panel
(see Fig. [1] ).
X
Connect the suction hose to the machine.
6.2 Switch on/off
X
Insert the plug into an earthed socket.
The use of extension cables in Zone 22
is not permitted.
The switch [1-9] serves as an on/off switch.
Switch position "0"
Appliance socket
[1-11] is disconnected from
the power, mobile dust extractor is switched
off.
"MAN" switch position
Appliance socket
[1-11] is connected to the
power, the mobile dust extractor starts.
"Auto" switch position
Appliance socket
[1-11] is connected to the
power, the mobile dust extractor starts when
the connected tool is switched on.
7 Settings
7.1 Adjusting the hose diameter
X
Adjust the hose diameter adjuster [1-8]
to match the diameter of the connected
hose.
L
The monitoring devices will measure the
air speed in the extractor hose correctly
as a result (see chapter 7.9).
WARNING
Unauthorised voltage or frequency!
Risk of accident
X
The mains voltage and the frequency of
the power source must correspond with
the specifications on the machine's name
plate.
X
In North America, only Festool machines
with the voltage specifications 120 V/60
Hz may be used.
CAUTION
Risk of injury from tools starting up un-
expectedly
X
Before setting the switch to the "AUTO" or
"MAN" position, make sure that the con-
nected tool is switched off.