Festool CTM 48 E-LE-AC B22 CLEANTEX - Manual (Page 16)

16
CTM 48 E LE EC/B22, CTL 48 E LE EC/B22 GB
7.2 Connecting electric power tools
X
Connect the electric power tool to the ap-
pliance socket [1-11] .
7.3 Connecting pneumatic tools
With the compressed air module [1-3] , the
automatic switch-on function for the mobile
dust extractor also works in conjunction with
air tools.
We also recommend installing the VE service
unit (495886). The service unit filters and lu-
bricates the compressed air and enables an
adjustment of the air pressure. An IAS
adapter (454757) is available to connect Fes-
tool air tools to the IAS system.
The operating pressure of the tool must be 6
bar for the automatic switch-on unit to func-
tion correctly.
7.4
Connecting the energy box
The connection for the energy box (EAA) [1-
4] allows you to connect the mobile dust ex-
tractor with the EAA in order to couple the
automatic switch-on unit on the mobile dust
extractor with the equivalent unit on the
EAA.
7.5 Adjusting the suction power
You can use the suction power adjuster [1-
10] to adapt the machine suction power to
different applications.
7.6
Applying the brake
Folding out the black brake lever [1-15] pre-
vents the mobile dust extractor from rolling.
To achieve this, lift the front end of the mo-
bile dust extractor slightly and push the
black brake lever downwards until it latches
into place. Push the green lever [1-14] again
to release.
7.7
Temperature cut-out
A temperature cut-out switches the mobile
dust extractor off when it reaches a critical
temperature to prevent overheating.
X
Switch off the mobile dust extractor and
allow to cool for approx. 5 minutes.
X
Change the cooling air filter if necessary
(see chapter 9.2).
L
If the mobile dust extractor will not switch
on again, please contact a Festool service
workshop.
7.8 Changing the filter bag (SC-FIS-
CT 48)
Removing the filter bag [4]
X
Open the locking clips [2-2] and remove
the top section of the machine [2-1] .
X
Remove the filter bag.
X
Dispose of the used filter bag in accor-
dance with statutory regulations.
Inserting the filter bag [5]
X
Insert a new filter bag (SC-FIS-CT 48) in
the inlet port of the dust container and in-
terlock it. Important: be aware that the
locking engages.
L
Make sure that the filter bag is not
pinched between the top and bottom sec-
tions.
X
Replace the top section [2-1] and close
the locking clips [2-2] .
7.9 Volumetric flow monitoring
An acoustic warning signal sounds if the air speed in the suction hose falls below 20 m/s.
WARNING
Risk of injury
X
Observe the maximum connected loads
for the appliance socket (see chapter
"Technical data").
X
Make sure that the power tool is switched
off before connecting or disconnecting.
WARNING
Risk of injury
X
Make sure that the pneumatic tool is
switched off before connecting or discon-
necting.
Possible causes Solution
Value set on the suction power adjuster [1-
10] is too low.
Set the suction power adjuster to a higher
value (see Chapter 7.5).
Rotary knob [1-8] not set to the correct
hose diameter.
Set the knob to the correct hose diameter (see
Chapter 7.1).
Suction hose blocked or kinked. Remove blockage or kink.