Festool CTM 48 E-LE-AC B22 CLEANTEX - Manual (Page 18)

18
CTM 48 E LE EC/B22, CTL 48 E LE EC/B22 GB
Damaged safety devices and components
must be repaired or replaced in a recognised
specialist workshop, unless otherwise indi-
cated in the operating manual.
Observe the following instructions:
– A dust test must be performed at least
once a year by the manufacturer or an in-
structed person. This test may include
checks to determine whether the filter is
damaged, the machine is sealed properly
and the monitoring features are function-
ing correctly.
– During maintenance and repair work, all
components that cannot be cleaned satis-
factorily must be replaced. The old compo-
nents must be sealed in impermeable
plastic bags prior to disposal in compliance
with applicable regulations for this type of
waste.
– Provided maintenance personnel or other
persons in the vicinity are not endangered,
the user must dismantle and clean the ma-
chine prior to performing maintenance
work. Appropriate precautionary measures
include decontaminating the machine prior
to disassembly, making provisions for lo-
cally filtered forced ventilation at the loca-
tion of machine disassembly, cleaning the
maintenance area and appropriate person-
al protective equipment.
9.1 Changing the filter element
X
Open the locking clips [2-2] and remove
the top section of the machine [2-1] .
X
Turn the top section of the machine so
that the main filter is facing upwards
(Fig. [7] ).
X
Fold over the lever [7-3] and remove the
retainer. [7-2]
X
Remove the used main filter and replace
[7-1] with a new one.
X
Dispose of the used filter in accordance
with statutory regulations.
X
Insert the retainer [7-2] and fold over the
lever [7-3] until it engages.
X
Replace the top section [2-1] and close
the locking clips [2-2] .
9.2 Changing the cooling air filter
[8]
Replace the cooling air filter if the mobile
dust extractor switches off due to excess
temperature and replace at least once a year.
L
We recommend that you always replace
the cooling air filter together with the
main filter.
X
Unscrew the cooling air cover [8-1] .
X
Remove the cooling air filter and replace
with a new one!
X
Close the cooling air cover.
9.3 Emptying the dust container
The dust container [2-3] can be emptied
once the top section has been removed.
X
After extracting fluids, clean the fill level
sensors [9-1] regularly with a soft cloth
and inspect for damage.
10 Accessories
Use only original Festool accessories and
Festool consumable material intended for
this machine because these components are
designed specifically for the machine. Using
accessories and consumable material from
other suppliers will most likely affect the
quality of your working results and limit any
warranty claims. Machine wear or your own
personal workload may increase depending
on the application. Protect yourself and your
machine, and preserve your warranty claims
by always using original Festool accessories
and Festool consumable material!
The order numbers for the accessories and
filters can be found in the Festool catalogue
or on the Internet at "www.festool.com".
NOTE
Motor damage
X
Never operate the extractor without a fil-
ter element fitted as the motor may be-
come damaged.
WARNING
Using non-approved accessories and
spare parts
Risk of explosion
X
Always use Festool approved accessories
and spare parts in Design 22 mobile dust
extractors - See accompanying spare
parts and accessories list.