Festool TS 55 R - Manual (Page 19)

TS 55
19
GB
 Adjust the guide play between the saw table and
the guide rail using the two adjustable jaws [9-
1].
Bed in the splinterguard [9-3] before using the
guide rail for the first time:
 Set the machine speed to 6.
 Place the machine at the rear end of the guide
rail together with the complete guide plate.
 Switch on the machine.
 Push down the machine slowly to the max. pre-
set cutting depth and cut along the full length of
the splinterguard without stopping.
The edge of the splinterguard now corresponds ex-
actly to the cutting edge.
11 Environment
Do not dispose of the device in house-
hold waste! Recycle devices, accesso-
ries and packaging. Observe applica-
ble country-specific regulations.
EU only: European Directive 2002/96/
EC stipulates that used electric power tools must
be collected separately and disposed of at an envi-
ronmentally responsible recycling centre.
Information on REACh: www.festool.com/reach
12 EU Declaration of Conformity
We declare under sole responsibility that this prod-
uct complies with the following directives and stan-
dards:
2006/42/EG, 2004/108/EG, 2011/65/EU (from
01.01.2013), EN 60745-1, EN 60745-2-5, EN 55014-
1, EN 55014-2, EN 61000-3-2, EN 61000-3-3.
Festool Group GmbH & Co. KG
Wertstr. 20, D-73240 Wendlingen, Germany
Dr. Martin Zimmer
Head of Research, Development and Technical
Documentation
29.11.2012
Plunge-cut saw Serial no.
TS 55 REBQ 498500
TS 55 REQ 498875
TS 55 RQ 498521
Year of CE mark: 2011