Edimax Technology ER-1088 - Manual (Page 19)

Figure 2-6: Primary Setup
Settings – Primary Setup
Connection
Mode • Interface – A pull down menu for each WAN port that you are going to
connect to the Internet.
• Connect Mode – Enable – Select this if you have connected a broadband
modem to this port. Disable – Select this if there is no broadband modem
connected to this port.
Connection
Type Check the data supplied by your ISP and select the appropriate option.
• Static IP – Select this if your ISP has provided a Fixed or Static IP address.
Enter the data into the Address Info fields.
• Dynamic IP – Select this if your ISP provides an IP address automatically
when you connect. You can ignore the Address Info fields.
• PPPoE – Select this if your ISP uses this method. (Usually, your ISP will
provide some PPPoE software; however, this software is not required and
should not be used.)
If this method is selected, you must complete the PPPoE dialup fields.
Note:
If using the PPTP connection method (enable PPTP Connection), select Static
IP or Dynamic IP as appropriate, according to the IP Address method used by
your ISP.
Page 15