Edimax Technology ER-1088 - Manual (Page 34)

Figure 4-2: Routing
Note:
If there is an entry or entries in the Routing table with an Index of zero (0), these are System entries.
You cannot modify or delete these entries.
Settings – Routing
Dynamic
Routing • RIP v2 – This acts as a “master” switch. If enabled, the selected WAN or LAN
will run RIPv1/v2, otherwise RIP function will not be available.
• Interface – If LAN or other WAN are enabled, the specified WAN or LAN can
execute RIP function.
Page 30