Edimax Technology ER-1088 - Manual (Page 85)

Data – System Status
WAN Interface • Connection Type – The type of connection used – DHCP, Fixed IP, PPPoE
or PPTP.
• Connection Status – Either "Connected" or "Disconnected”.
• "Force Renew" button– Only available if using a dynamic IP address
(DHCP). Clicking this button will perform a DHCP "Renew" transaction with
the ISP's DHCP server. This will extend the period for which the current
WAN IP address is allocated to you.
• Connect/Disconnect – Used for dial-up/connection of PPPoE or PPTP.
• IP Address – The IP address of the Multi-WAN VPN Link Balancer, as seen
from the Internet. This IP Address is allocated by the ISP (Internet Service
Provider).
• Subnet Mask – The Network Mask (Subnet Mask) for the IP Address above.
• Domain Name IP Address – The address of the current DNS (Domain
Name Server)
• Gateway – The address of the Multi-WAN VPN Link Balancer gateway.
• MAC Address – The MAC (physical) address of the Multi-WAN VPN Link
Balancer, as seen from the Internet.
LAN Interface • IP Address – The LAN IP Address of the Multi-WAN VPN Link Balancer.
• Subnet Mask – The Network Mask (Subnet Mask) for the IP Address above.
• MAC Address – The MAC (physical) address of the Multi-WAN VPN Link
Balancer, as seen from the local LAN.
• DHCP Server – The status of the DHCP Server function - either "Enabled"
or "Disabled".
Device
Information • Hardware ID – The manufacturers ID for this particular device.
• Firmware Version – Version of the Firmware currently installed.
• NAT – Status of the NAT feature – either “Enable” or “Disable”.
• Load Balance – Status of the Load Balance feature – either “Enable” or
“Disable”.
• Virtual Server – Status of the Virtual Server feature – either "Enabled" or
"Disabled".
• Special Applications – Status of the Special Applications feature – either
"Enabled" or "Disabled".
• Multi DMZ – Status of the Multi DMZ feature – either "Enabled" or
"Disabled".
• Block URL – Status of the Block URL feature – either “Enable” or “Disable”.
Page 81