Edimax Technology HP-2002APn - Manual (Page 37)

35
Field Description
If this value is 1, it means the client is in the charge of the
access commands.
Ackpolicy When WMM packets are transmitting, AP will receive an
echo request. If you set this value is 0, it means AP does
not send back an echo request, which will brings positive
effect for WMM. If this value is 1, AP generates the
response to the request.
Note: HP-2002APN provides standard WMM settings. If you want to modify the parameters above, please
refer to the WMM settings of your WMM products.
3) DLS (Direct Link Setup)
HP-2002APN provides DLS function. Suppose that there are two WMM
devices. Enter the MAC address of a WMM device in the DLS setting of the
other device, and then connect the two WMM devices to the HP-2002APN. In
this way, the two WMM devices can transmit message directly.
If you want to configure WMM DLS, do as follows:
Step 1
Prepare two wireless network cards (A and B) and one HP-2002APN.
Step 2
Enable the DLS function on the Advanced Wireless Settings page.
Step 3
Enable the DLS function of wireless network cards. Enter the MAC
address of wireless card A on the WMM page of the wireless network
card B, and then click the Apply button.