STIEBEL ELTRON SHW ... S с 06.05.2013 - Manual (Page 29)

www.stiebel-eltron.com SHW S | 29
EN
GL
ISH
16.3 Heat-up diagram
The heat-up time depends on the cylinder capacity, cold water
inlet temperature and heating output.
At 10 °C cold water temperature and temperature setting "E":
400 300
2
4
6
8
10
12
2
3
4
1
84
�0
2�
02
�0
01
6
X Nominal capacity [I]
Y Duration [h]
1 2 kW
2 3 kW
3 4 kW
4 6 kW
16.4 Fault conditions
In the event of a fault, temperatures of up to 95 °C at 0.6 MPa
can occur.
16.5 data table
SHW 200 S SHW 300 S SHW 400 S
182120 182121 182122
Hydraulic data
Nominal capacity
l 200 300 400
Amount of mixed water 40 °C (15 °C/60 °C) l 397 590 780
Electrical data
Connected load ~ 230 V
kW 2-4 2-4 2-4
Connected load ~ 400 V kW 2-6 2-6 2-6
Rated voltage V 230/400 230/400 230/400
Phases 1/N/PE,3/N/PE 1/N/PE,3/N/PE 1/N/PE,3/N/PE
Frequency Hz 40-450 40-450 40-450
Single circuit operating mode X X X
Dual circuit operating mode X X X
Application limits
Temperature setting range
°C 35-82 35-82 35-82
Max. permissible pressure MPa 0.6 0.6 0.6
Test pressure MPa 0.78 0.78 0.78
Max. permissible temperature °C 95 95 95
Max. flow rate l/min 30 38 45
Energy data
Standby energy consumption/24 h at 65 °C
kWh 1.5 1.9 2.25
Versions
IP rating
IP24 IP24 IP24
Sealed unvented type X X X
Colour pure white/basalt grey pure white/basalt grey pure white/basalt grey
Dimensions
Height
mm 1578 1593 1763
Width mm 630 700 750
Depth mm 730 815 865
Weight
Weight, full
kg 265 277 490
Weight, empty kg 65 77 90
WaRRanty | envIROnMent and
RecyclIng
Warranty
The warranty conditions of our German companies do not
apply to appliances acquired outside of Germany. In countries
where our subsidiaries sell our products, it is increasingly the
case that warranties can only be issued by those subsidiaries.
Such warranties are only granted if the subsidiary has issued
its own terms of warranty. No other warranty will be granted.
We shall not provide any warranty for appliances acquired in
countries where we have no subsidiary to sell our products.
This will not affect warranties issued by any importers.
Environment and recycling
We would ask you to help protect the environment. After use,
dispose of the various materials in accordance with national
regulations.
InStallatIOn | WaRRanty | envIROnMent and RecyclIng
Specification