Inspecting and changing fuses, Come on normally, 2 inspecting and changing fuses p. 263 – HONDA 2012 Fit User Manual
Page 264
263
uu
Fuses
u
Inspecting and Changing Fuses
Han
d
lin
g the U
n
expected
Inspecting and Changing Fuses
1. Turn the ignition switch to LOCK
(
0
. Turn
headlights and all accessories off.
2. Check the fuses in the engine
compartment.
u
If the fuse is blown, have it replaced by a
dealer.
3. Inspect the small fuses in the engine
compartment and the vehicle interior.
u
If there is a burned out fuse, remove it
with the fuse puller and replace it with a
new one.
1
Inspecting and Changing Fuses
NOTICE
Replacing a fuse with one that has a higher rating
greatly increases the chances of damaging the
electrical system.
Replace fuse with a spare fuse of the same specified
amperage.
Confirm the specified amperage using the charts on
and
There is a fuse puller on the back of the engine
compartment fuse box cover.
Fuse
Blown
Fuse Puller
US FIT-31TK6630.book 263 ページ ２０１１年６月１５日 水曜日 午後４時２３分
2012 Fit
Home
QRG
Index
TOC