Lights – HONDA 2012 Ridgeline User Manual
Page 347
![background image](/manuals/240864/347/background.png)
Remove the socket from the
headlight assembly by turning it
one-quarter turn counterclockwise.
Pull the bulb straight out of its
socket. Push the new bulb straight
into the socket until it bottoms.
Turn on the lights to make sure
the new bulb is working.
Put the inner fender cover in place.
Install and lock each holding clip
by pushing on the center.
Insert the socket back into the
headlight assembly. Turn it
clockwise to lock it in place.
To change the passenger’s side
bulb, start the engine, turn the
steering wheel all the way to the
left, and turn off the engine. To
change the driver’s side bulb, turn
the steering wheel to the right.
Use a flat-tip screwdriver to
remove the two holding clips from
the inner fender, and pull the inner
fender cover back.
5.
6.
1.
2.
3.
4.
7.
Replacing a Front Turn Signal/
Hazard/Parking Light Bulb
Lights
Ma
int
e
na
nce
339
HOLDING CLIPS
BULB
SOCKET
11/09/14 18:16:00 31SJC660_346