HONDA 2011 CR-V - Manual (Page 180)

This function
samples the first track of each disc
in the in-dash disc changer in the
order they are stored. To activate
disc scan, press the SCAN button
repeatedly until you see D-SCAN in
the display. The system will then
play the first track/file of the first
disc for approximately 10 seconds.
After playing the first track/file of
the last disc, the system plays
normally.
To remove the disc currently in play,
press the eject button. When a disc is
removed from a slot, the system
automatically begins the load
sequence so you can load another
disc in that position. If you do not
remove the disc from the changer
within 10 seconds, the disc will
reload into the slot. Then the system
returns to the previous mode (AM,
FM, or XM Radio ).
To play the radio when a disc is
playing, press the AM, FM, or XM
button (EX-L). Press the AUX or
CD/AUX button to switch to an
appropriate audio unit (if it is
connected to the USB adapter cable
or the auxiliary input jack). Press the
CD or CD/AUX button again to
switch back to playing a disc.
You can also press the MODE
button on the steering wheel to
change modes.
If you turn the system off while a
disc is playing, either with the
(
) button or by turning off the
ignition switch, the disc will stay in
the drive. When you turn the system
back on, the disc will begin playing
where it left off. : On EX-L model
Playing Discs (EX and EX-L models without navigation system)
DISC-SCAN Removing Discs f rom the In-dash
Disc Changer To Stop Playing a Disc
174
10/07/09 18:31:50 31SWA640_179