M-AUDIO EQMan - Manual (Page 7)

7
Fig. 1 here
Factory Default Jumper Settings
Physical Installation
The EQMan should be installed into your computer only after a
potential address setting for the card has been determined and properly
set on the card itself. Make sure you have performed the above
instructions related to address selection and that the EQMan jumpers
have been set accordingly. Only then should you proceed and
physically install the EQMan. When ready to install the EQMan in
your computer, follow these steps:
1. Turn off your computer.
2. Remove the cover and position the computer so you have easy access
to the slots.
3. Select the slot in which you wish to place your EQMan card (make
sure that it is an ISA slot. If you don’t know what “ISA slot” means,
check the owner’s manual of your computer) and remove the metal
bracket that covers the access hole on the back of the computer.
4. Position the EQMan card over the slot and fit the card loosely over it
with the EQMan card upright. Then press the card downward into
the slot gently but firmly until the card is completely and squarely
seated in the slot.
5. Screw the EQMan's metal bracket down into the screw hole on the
back of your computer.
6. Place the cover back on your computer.
7. If you want, at this point, you may connect the audio cables to the
back of the EQMan. We recommend that you label the free ends of
the cables so you won’t have to look at the back of the computer if
you have to re-patch your audio devices later.
8. Move your computer back to its original position. You may now
turn on your computer.
Diagnostic Software
Included with the EQMan is DOS diagnostic software. After the
EQMan has been configured and physically installed in your computer,
you should run the diagnostic software file EQMNDIAG.EXE -- its
purpose is to verify proper installation and operation of the EQMan
card.
IMPORTANT: Because Windows may disable direct access to the
EQMan hardware and cause the diagnostics to malfunction, the DOS
diagnostic program EQMNDIAG.EXE should only be run from the