Candy PC PVD 830 N - Manual (Page 10)

L
3
L
2
L
1
220-240V 3~ H05V2V2-F 4G 2.5mm 2
N
L
1
L
2
L
3
380-415V 3N~ H05V2V2-F 5G 2.5mm 2
L
N
220-240V 1N ~ H05V2V2-F 3G 2.5mm 2
L
2
L
1
N
380-415V 2N~ H05V2V2-F 4G 2.5mm 2 L
1
L
2
220-240V 2~ H05V2V2-F 3G 2.5mm 2
25 min.
30 mm
40 mm
755
305
50
Min
50
Min
53.5
Min
320
770
POSITIONING (Fig.7)
The domestic appliance is designed to be built into a worktop as illustrated in the specific figure. Apply sealant around
the entire perimeter (cut-out dimensions Fig.7B). Fix the domestic appliance on the worktop by means of the 4
brackets provided, taking the thickness of the worktop into account (Fig.7A). If the lower part of the appliance, after
installation, is accessible via the lower part of the cabinet then it is necessary to mount a separator panel respecting
the distances indicated (Fig.7C). If the appliance is installed with an oven underneath then the separator is not
necessary.
ELECTRICAL CONNECTIONS (Fig.8)
Before making the electrical connections, check that:
-
the ground cable is 2 cm longer than the other cables;
- the system ratings meet the ratings indicated on the identification plate fixed on the lower part of the worktop;
- the system is fitted with efficient earthing compliant to the laws and regulations in force.
Earthing is obligatory by law.
If the domestic appliance is not fitted with a cable and/or relevant plug, use material suited to the absorption value
indicated on the identification plate and the operating temperature. At no point must the cable reach a temperature
50°C higher than room temperature.
If wishing to make a direct connection to the mains, an omnipolar switch must be interposed with a minimum opening
of 3 mm between the contacts and suited to the load indicated on the plate and conform to the regulations in force
(the yellow/green ground conductor must not be interrupted by the switch). When the appliance has been installed,
the omnipolar switch must be easily reachable.
Attention: On the basis of the model in possession the electronic board may be protected by eventual errors caused
in the electrical network connection by a fuse on the board.
If replacement is necessary, use a fuse that has exactly the same technical specifications.
Fig.7
Fig.8
A
B
C