Candy PC PVD 830 N - Manual (Page 11)

USE AND MAINTENANCE
MAINTENANCE
Remove any residues of food and drops of grease from the cooking surface using the special scraper supplied on
request (Fig.2)
Clean the heated area as thoroughly as possible using SIDOL, STAHLFIX or similar products and a cloth/paper, then
rinse with water and dry with a clean cloth.
Using the special scraper (optional) immediately remove any fragments of aluminium and plastic material that have
unintentionally melted on the heated cooking area or residues of sugar or food with a high sugar content (Fig.2). In
this way, any damage to the cooktop surface is prevented.
Under no circumstances use abrasive sponges or irritating chemical detergents such as oven sprays or stain
removers.
· CONTROL AREA (Fig.3)
- At the first ignition the cook top will be in the safety position, that is the “key button warning light on/off” will be
switched on.
- To use the cook top it will be necessary to keep the “key button” depressed for 3 seconds until the “key button
warning light on/off” switches off.
To turn on the desired heating element :
- depress the corresponding on/off key. The “led” of the “Cooking zone display” will be visualized flickering .
- depress the key within 10 seconds - to go to position 4 or the + key to go to position 9.
- To regulate the temperature of the cooking zone use the + or - keys.
- If the hotplate is supplied with an extensive area, to switch the second area on bring the “Display of the cooking
area” to position 9 and press the button + for 2 sec: until the decimal point is switched on to confirm.
- To switch the hotplate off press the relative on/off button.
NOTE:( During operation it will be possible to block / unblock the control zone by depressing the key button for 3
seconds).
· Timer Area (Fig.3)
The surface has the possibility to set the timer simultaneously on every cooking area. The timer is a function that
allows setting a time (from 1 to 99 minutes) to automatically switch off the selected cooking area.
- Press the “Timer” button for 2 seconds: the display shows “00” in the centre and it will show which element is active
on the right and left side.
- By continuing to press the “Timer” button the hotplate is selected amongst those active.
- Press + or - to select the “Timer” value.
NOTE:
- If the “Timer” function has been imposed for more than one cooking area, the “Timer Display” will show every 3
seconds the remaining time for every programmed area.
- To cancel the “Timer” function, switch off the relative cooking area.
· “MEMORY” function
If your product has the MEMORY function, the programming and execution of a cooking cycle on very heating
element is permitted.
Note:
- One cycle at a time can be carried out in registration or in execution.
- The variations of power level for the times inferior to 15 sec. are not registered.
- One cooking cycle with a maximum duration of 10 hours and a maximum of 10 variations of the power level can be
memorised.
· Memorisation of a cooking cycle
- Press the “Memory” button and then select the desired hotplate by means of the relative “ON/OFF” button.
- Press the buttons + or - until the desired power is selected.
- To terminate the memorisation cycle press once again the button “ON/OFF”.
· Executing a cooking cycle
- To execute a cooking cycle already memorised, it is sufficient to press the “ON/OFF” button of the interested
cooking area followed by the “Memory” button.
· Display
The cooking surface is supplied with a display that in normal function is a “WARCH” and can also carry out the
“COUNTDOWN” function when the surface is off.
· Regulation of the Watch
In the installation phase set the clock in the following way:
- Unblock the cooking surface by keeping the “key button” pressed down for 3 seconds until the “indicator light
button” is switched off.