Panasonic SDR-S10 - Manual (Page 103)

Others
103
VQT1E14
Recording does not
start although the
power is supplied
to this unit and the
SD card is correctly
inserted.
≥ Has the SD card’s write protect switch been set to
LOCK?
# No recording is possible while the write protect switch
is set to LOCK. (l 17)
≥ Is the memory of the card full?
# If the card has no more available memory, free up
some memory by deleting unnecessary scenes (l 66)
or use a new card.
≥ Is the unit set to the video recording mode or picture
recording mode?
# No recording is possible unless the mode dial is at
or .
≥ Is the card/battery door open?
# If the card/battery door is open, this unit will not
operate normally. Close the card/battery door and slide
the card/battery door lock to LOCK.
Recording stops
suddenly during
motion picture
recording on a
card.
≥ When using an SD card on which data has been
written many times and the data writing speed has
reduced, the recording may suddenly stop during
motion picture recording.
# Use a card recommended as suitable for motion
picture recording. (l 17)
If the recording stops even when a suitable SD card is
used, back up the data on the card to a computer, etc.
and then format the card. (l 70)
Recorded still
pictures are not
clear.
≥ Are you trying to record small or finely detailed
objects with [PICT. QUALITY] set at [ ]?
# If you try to record small or finely detailed objects with
[PICT. QUALITY] set at [ ], the images may break
up into a mosaic-like pattern. Record with
[PICT. QUALITY] set at [
] instead. (l 44)
Problem Check points
VQT1E14(EB_GC_ENG).book 103 ページ ２００７年２月２８日 水曜日 午後２時２３分