Panasonic SDR-S10 - Manual (Page 21)

21
VQT1E14
Setup
charging the battery again. If the
battery still fails to charge, something
may be wrong with the unit, battery, AC
adaptor etc. Contact your dealer.
When the status indicator is off:
≥ Charging is completed.
≥ When the status indicator does not
flash, reinsert the battery or the AC
adaptor. If the status indicator still does
not flash, there may be a problem with
the battery or the AC adaptor. Contact
your dealer.
∫ Connecting to the AC
outlet
Be sure to set the mode dial to OFF
when connecting the AC adaptor to
this unit.
If you turn on this unit while charging the
battery using the AC adaptor, you can
use the power supplied from the AC
outlet to power the unit for use. (While it
is in use, the battery will not be charged.)
≥ Be sure to set the mode dial to OFF
and check that the status indicator is
off before removing the battery.
1
Slide the card/battery door
lock in the direction of arrow
and then open the card/battery
door.
≥ When the card/battery door does not
open, place your finger on the [ ] part
and open the card/battery door.
2
Slide the lock A in the
direction of the arrow and
then remove the battery.
3
Close the card/battery door
and then slide the card/battery
door lock in the direction of
the arrow.
To remove the battery
A
BATT
VQT1E14(EB_GC_ENG).book 21 ページ ２００７年２月２８日 水曜日 午後２時２３分