Panasonic SDR-S10 - Manual (Page 104)

Others
104
VQT1E14
Auto focus
function does not
work.
≥ Is manual focus mode selected?
# Set the unit to auto focus mode by pressing the AUTO
button.
≥ Are you trying to record a scene which is hard to
bring into focus in auto focus mode?
# There are some recording subjects and surroundings
for which the auto focus does not operate correctly.
(l 112) If so, use the manual focus mode to adjust the
focus. (l 55)
Sound is not
played back from
the built-in speaker
of this unit.
≥ Is the volume too low?
# During playback, press the volume button to display
the volume indication and adjust it. (l 62)
During playback,
the sound from the
camera’s motor is
heard in the
recording.
≥ This is a mechanical sound of the camera, but it is not
a malfunction.
≥ Are there drops of water on the microphone?
# The recorded mechanical sound may become louder
and the microphone’s sensitivity may decrease when
there are drops of water on the microphone.
Wipe off any drops of water and then leave the unit to
dry naturally.
The speaker
volume during
playback is low.
≥ Are there drops of water on the microphone?
# The volume of the output sound may decrease when
the speaker is wet.
After wiping off any drops of water and then leaving the
unit to dry naturally, it will return to normal.
Although this unit
is correctly
connected to a TV,
playback images
cannot be seen.
The playback
images are
squeezed
horizontally.
≥ Have you selected video input on the TV?
# Please read the operating instructions of your TV and
select the channel that matches the input used for the
connection.
≥ Is the [TV ASPECT] setting correct?
# Change the setting to match the aspect ratio of the TV.
Press the MENU button, then select [SETUP] #
[TV ASPECT] # [16:9] or [4:3] and press the cursor
button in the centre.
Problem Check points
VQT1E14(EB_GC_ENG).book 104 ページ ２００７年２月２８日 水曜日 午後２時２３分