Acclaim Lighting XB-R1 Setup tool - Manual (Page 12)

User’s Manual
12
Unit Group:1~100; Unit Number:1~999; Total Channel:1~48.
① It is necessary to set the first LED properly in Setup With Answer Menu before entering.
② DMX Addresses of LEDs depend on work modes.
③ Work Mode settings for all LEDs Unit should be compatible. If not, it will return to the previous
menu automatically.
④ After the first LED unit confirmation and scanning all units, Unit Number will also increase one
automatically, and DMX address are the total of LEDs channels. If the unit number over 999, unit
number is beginning from 1. Finishing all settings of LED Units, it will return to the menu of Setup
With Answer automatically. And this function is used to set LED unit first, then connect.
4.3 DMX Controller
Page(I)
If you select the “DMX Controller” function mode, then press the multi-selector, the LCD-display will
show you as below:
Page(II)
Note: In DMX Controller function, Single Channel Mode, 512 Channel Mode and Auto Chase
Mode are available.
*For your reference, we respectively take the Single Channel Mode, 512 Channel Mode and Auto
Chase Mode for example:
(1) Single Channel Mode:
In Single Channel Mode, user can rotate the multi-selector clockwise or anticlockwise to select
relevant items (Mode: MANUAL, AUTO ON/OFF, AUTO FADE; DMX Channel: 1~512; Time/50mS:
1~200; Intensity: 0~255.) And then press the multi-selector to confirm your setting.
Note: In Manual Mode, user can adjust the output intensity up to the need. And in other modes, the
output intensity will vary automatically at the range of 0~255.
< Setup No Answer >
Setup With Answer >
DMX Controller >
LCD Backlight:xxxx >
> DMX Mode Select
Single Channel >
512 Channel >
Auto Chase >
< Mode: MANUAL >
Channel: XXX >
Time/50mS: XXX >
Intensity: XXX >
> DMX Mode Select
Single Channel >
512 Channel >
Auto Chase >