Acclaim Lighting XB-R1 Setup tool - Manual (Page 6)

User’s Manual
6
(3) MANUAL Work Mode:
 If you set the Work Mode as “MANUAL”, the LCD-display will immediately show you as below:
You can rotate the multi-selector clockwise or counterclockwise to select relevant item, then use the
multi-selector to adjust or confirm your setting.
In the MANUAL Work Mode, relevant parameters are as below:
Blue/Duration: 0%-100%
Red /Speed: 0%-100%
Green/Dimmer: 0%-100%
Select the “Confirm” item and press the multi-selector, LCD will show you the above display.
(When adjusting relevant parameters, the being-controlled LEDs will respond sensitively.
The LEDs will briefly flash for several seconds during data sending.)
* User can call up Semiautomatic Setup No Answer function by rotating the multi-selector and
selecting the “Selective Copy”, then press the multi-selector, the LCD will show you as below:
Unit Group:1~100; Unit Number:1~999; Total Channel:1~48.
① It is necessary to set the first LED properly in Setup No Answer Menu before entering.
② DMX Addresses of LEDs depend on work modes.
③ DMX Addresses are channel total of LEDs after confirmation. And Unit Number would increase
< Unit Number: XXX
>
Work Mode:MANUAL >
Blue/Duration: XXX % >
↓
Red /Speed: XXX % >
Green/Dimmer: XXX % >
Confirm to send >
Selective Copy >
Copy to all >
↑Blue
/Duration: XXX % >
Red /Speed: XXX % >
Green/Dimmer: XXX % >
Confirm to send >
Unit Number Mode
LED Unit Setup
Data Sending！
Please Wait…
< Unit Number: XXX >
Work Mode: RGB >
Glide Effect: XXX >
↓
Address Set: XXX >
Confirm to send >
Selective Copy >
Copy to all >
< Unit Group: XXX >
Unit Number:XXX >
Total Channel:XXX >
Addr: XXX Confirm >