Acclaim Lighting XB-R1 Setup tool User Manual
Page 7
User’s Manual
7
once automatically, user can select the next LED by changing Unit Number and Unit Group.
Select the “Confirm” item and press the multi-selector, LCD will show you the above display.
(When adjusting relevant parameters, the being-controlled LEDs will respond sensitively.
The LEDs will briefly flash for several seconds during data sending.)
*
User can call up Automatic Setup No Answer function by rotating the multi-selector and selecting
the “Copy to all”, then press the multi-selector, the LCD will show you as below:
Unit Group:1~100; Unit Number:1~999; Total Channel:1~48.
① This function is only asked when parameters of all LEDs have been set up properly.
② It is necessary to set the first LED properly in Setup No Answer Menu before entering.
③ DMX Addresses of LEDs depend on work modes.
⑤ DMX Addresses are channel total of LEDs after confirmation. And Unit Number would increase
once automatically, user can select the next LED by changing Unit Number and Unit Group. The
DMX address is beginning from 1 when passing 512.
Select the “Confirm” item and press the multi-selector, LCD will show you the above display.
(When adjusting relevant parameters, the being-controlled LEDs will respond sensitively.
The LEDs will briefly flash for several seconds during data sending.)
<
Unit Number:
XXX
>
Work Mode: RGB
>
Glide Effect: XXX
>
↓
Address Set:
XXX
>
Confirm to send >
Selective Copy >
Copy to all >
< Unit Group: XXX >
Unit Number:XXX >
Total Channel:XXX >
Addr: XXX Confirm >
Unit Number Mode
LED Unit Setup
Data Sending！
Please Wait…
< Unit Group: XXX >
Unit Number:XXX >
Total Channel:XXX >
Addr: XXX Confirm >
Unit Number Mode
LED Unit Setup
Data Sending！
Please Wait…
< Unit Group: XXX >
Unit Number:XXX >
Total Channel:XXX >
Addr: XXX Confirm >