Acnodes FES 7610 - Manual (Page 42)

© Copyright 2009 Acnodes, Inc.
All rights reserved. Product description and product specifications
are subject to change without notice. For latest product information,
please visit Acnodes’ web site at www.acnodes.com.
661 Brea Canyon Rd., Suite 3
Walnut, CA 91789
tel: 909.598.7388, fax: 909.598.0218, www.acnodes.com
FES7610
Fanless Embedded Controller comes with
Intel Celeron M ULV 1.0GHz Processor
IDE Channel 0 Master
IDE Channel 0 Slave
The BIOS can automatically detect the specifications and optimal operating mode of almost all IDE hard
drives. When you select type AUTO for a hard drive, the BIOS detect its specifications during POST, every
time system boots.
If you do not want to select drive type AUTO, other methods of selecting drive type are available:
1. Match the specifications of your installed IDE hard drive(s) with the preprogrammed values for
hard drive types 1 through 45.
2. Select USER and enter values into each drive parameter field.
3. Use the IDE HDD AUTO DETECTION function in Setup.
Here is a brief explanation of drive specifications:
Type: The BIOS contains a table of pre-defined drive types. Each defined drive type has a
specified number of cylinders, number of heads, write precompensation factor, landing zone, and num-
ber of sectors. Drives whose specifications do not accommodate any predefine type are classified as
type USER.
o Size: Disk drive capacity (approximate). Note that this size is usually greater than the size of a
formatted disk given by a disk-checking program.
o Cyls: number of cylinders.
o Head: number of heads.
o Precomp: write precompensation cylinders.
o Landz: landing zone.
o Sector: number of sectors.
o Mode: Auto, Normal, Large or LBA.
Auto: The BIOS automatically determines the optimal mode.
ƒ Normal: Maximum number of cylinders, heads, sectors supported are 1024, 16 and 63.
ƒ Large: For drives that do not support LBA and have more than 1024 cylinders.