ACR&Artex B406-4 - Manual (Page 62)

ACR ELECTRONICS, INC / ARTEX PRODUCTS
DESCRIPTION, OPERATION, INSTALLATION AND MAINTENANCE MANUAL
B406-4 (453-5004)
25-62-03
Page 62 of 87
JUN 20/13
Figure 16. Blade Antenna 110-337-11 Outline and Dimensions
TASK 25-62-03-450-803
4. Remote Switch Panel
SUBTASK 25-62-03-450-001
A. Location
NOTE: In most cases, panel space and wiring have been pre-provisioned by the aircraft
manufacturer for the G737 control panel (remote switch panel assembly); however, location
and installation requirements are defined for installations in aircraft not pre-provisioned for
this remote switch panel.
(1) The Control Panel G737 (453-0161) must be mounted in the cockpit where the pilot can easily
reach the switch and see the status light.
(2) The panel assembly requires a space approximately 5.74 x 2.24 in. (146 x 57 mm) on the
panel or console surface, with a depth of 3.00 in. (77 mm), excluding room for the harness
2.25
(57)
0.562 (14.3)
8.25
(210)
6.000
(152.4)
3.000
(76.2)
1.620 (41.2)
1.500
(38.1)
0.750 (19.1)
1.25 (32)
0.625 (15.9)
0.201 (5.1) Ø (6 PLCS)
Dimensions in inches (mm)
110-337-11
1.160 (29.5)
5.580
(141.7)
RF CONNECTOR BNC FEMALE
RF CONNECTOR
TNC FEMALE
7.85
(199)
30º
15º
INSTALLATION NOTES:
1. MOUNT ANTENNA USING #10-32 SS MACHINE SCREWS AND
ASSOCIATED HARDWARE AND TORQUE TO 20 IN/LBS.
2. PROVIDE A 5/8" (.625") DIAMETER HOLE FOR THE BNC CONNECTOR.
3. PROVIDE A 5/8" (.625") DIAMETER HOLE FOR THE TNC CONNECTOR.
4. A LAYER OF ANTI-CORROSION BOUNDING GREASE SHOULD BE
APPLIED BETWEEN THE AIRCRAFT AND THE BASE OF THE ANTENNA
5. THIS ANTENNA IS BOUNDED THRU THE MOUNTING SCREWS.
6. GASKET IS NOT SUPPLIED AND USE IS OPTIONAL.
CONTACT ACR/ARTEX AND REQUEST PART #280-0340 IF ONE IS DESIRED.