Acroprint ESP180 Time Stamp - Manual (Page 11)

11
2.5 ESP180 installation
You have your choice of mounting the ESP180 on a wall or
placing it on a smooth, dry surface. If you install it on a table top
or a desk, be sure the power cord is safely stored so that it does
not interfere with surrounding walking space.
If you choose to mount it on a wall, we recommend you use a
wood surface or any other material that can support the weight of
the unit. We advise you not to mount it directly on drywall.
If the wall is your choice, you must remove the wall mounting
bracket on the back of the clock. To do so, insert the key and turn
it counterclockwise. Then slide the bracket down and away from
the clock. Next, remove the key.
We recommend 48" as the installation height from the floor to the
bottom of the wall mounting bracket.
You should mark the screw locations by using the bracket as a
template. As you hold the bracket level, fasten the unit to the wall
by using the three screws furnished.
Then, having placed the clock against the wall, guide the clock
onto the bracket, being careful not to pinch the power cord.
Finally, press downward until the clock snaps securely into place.
You should not be able to lift the clock off the bracket without
unlocking it.
2.6 Printing/adjusting depth of print
Once the ribbon is installed and the power connected, you’re
ready to print. Insert a time card until the card stops, then press
the print bar. You may adjust the card stops to control how close
the ESP180 prints to the edge. The ESP180 is shipped with the
card stops pushed all the way towards the front. This allows the
ESP180 to print close to the edge of paper. To increase the print
distance from the edge, push the card stops towards the back of
the unit.
Setup