Setting the 1st command line, Set 1st character code – Acroprint ES900 Electronic Time Recorder User Manual
Page 41
Advertising
![background image](/manuals/248102/41/background.png)
ES900 User’s Manual
35
Setting the 1st Command Line
1. Press SELECT until the S is under the "COMMENT" mark.
2. The flashing digit indicates "Character Position".
3. Press SET.
Set 1st Character Code
1. The flashing digit changes from "Character Position" to "Character Code".
2. In this example, the 1st character is "A". Press CHANGE until the Character Code is"02" (A).
Refer to
“Character Code for Alphanumeric” on pages 64
.
3. Press SET.
$%&+27(/
2&7
%267210$
$%&+27(/
2&7
%267210$
$OLJQ/HIW
&HQWHU
$OLJQ5LJKW
$%&+27(/
2&7
%267210$
COMMENT
SELECT
CHANGE SET
Advertising