Activeforever Invacare Semi-Electric Home Care Hospital Bed - Manual (Page 29)

SECTION 4—PACKAGING, HANDLING, AND SET-UP
Part No 1114836 29 IVC ™ Bed Series
FIGURE 4.10 Assembling the Drive Shaft
Inspecting the Bed
Electric Beds
ƽ WARNING
When installing any connectors into the junction box, be sure the cable lock is
secure after installation - otherwise, injury or damage may occur.
NOTE: For this procedure, refer to FIGURE 4.11 on page 30.
NOTE: The following procedure is for full/semi-electric beds only.
All motors, the junction box, connectors and wiring are located on the foot spring section.
All connectors will arrive plugged into the junction box. If a connector is not plugged into
the junction box when received or if a function of the bed is not working use the color
coding to check the placement of the connectors. Each connector and junction box slot is
color coded.
NOTE: The color rings on the cables are not visible when the cables are plugged in and the cable
lock is attached.
1. Inspect the power supply cord and motor cables for cuts or damage to the cord and/or
plug.
FOOT
END
HEAD
END
DETAIL "A"
Hi/Lo Motor Output
Shaft Spring-Loaded Coupler
Top Gear Box
Output Drive Shaft
Bed End
Drive Shaft
Hi/Lo Motor Output Shaft
(Full electric only)
Hi/Lo Motor Output Shaft
(Full electric only)
LOCKED POSITION
Hi/Lo Motor Output Shaft
Spring-Loaded Coupler
Hi/Lo Motor
Output Shaft
Spring-Loaded
Coupler Shaft
OUTPUT SIDE
Top Gear Box
Output Drive Shaft
Bottom Gear Box
Output Drive Shaft (Covered)
Gear
Box
INPUT SIDE
Drive Shaft Cover
Input Drive Shaft
(Covered) Hi/Lo Motor
UNLOCKED POSITION
Gear
Box
Drive Shaft Cover
Drive
Shaft