Activeforever Geemarc AMPLI600 Emergency Response Phone - Manual (Page 28)

28
Setting the Remote Audio Monitoring Access PIN Code
The speakerphone will identify the PIN number for Remote Audio Monitor-
ing. The Access PIN code is factory preset to the sequence 1234. It can be
changed as follows:
Press MUTE
Use ▲ or ▼ to select ‘SET SOS’
Press OK
Use ▲ or ▼ to select ‘PIN CODE’
Press OK
Use C to delete existing digits
Enter your new code (max 4 digits)
Press OK
Press C twice to exit
Using Remote Audio Monitoring
These are instructions for your remote emergency contact caller. Ensure
you provide them with the remote PIN code!
1. Dial as if it was a regular phone call. You will hear a “beep” after 10
dialing tones.
2. You will have 10 seconds to enter the Remote Audio Monitor Access
PIN Code on your keypad (the access code is 1234 unless it has been
changed). This turns on the speakerphone of the AMPLI600 phone
and allows you to listen in and have a two-way conversation.
3. Every 2 minutes another “beep” will be audible and you will need to
press any of the 0-9 keys to continue; otherwise the AMPLI600 will
hang up.
REMOTE MONITORING