Activeforever Geemarc AMPLI600 Emergency Response Phone - Manual (Page 43)

43
call is from an area not providing caller display, Unavailable number
will be displayed
● It could be a call from a PBX. Caller display may not work properly if
the telephone is connected to a PBX
No response on LCD display
● If you have experienced a power failure the batteries may become
weak. If the power is restored and the LCD display still does not re-
spond then replace the batteries with new ones.
No Strobe Ringer and/or bed shaker will not activate
● Make sure the strobe and/or shaker switch is turned “ON
● Make sure the Bed Shaker is plugged in correctly
No amplification
● 1. Check to see if the AMPLI amplify button is “ON”. You should see
the red light
There is Interference on the line
● A filter may be required for homes with DSL line.
There is a red light that continues to flash.
● You have un-reviewed Caller ID / Call Waiting information or missed a
call.
No Numbers in memory
● No number stored in that memory button.
● If your phone has been disconnected for a few hours the numbers
stored will be lost.
Emergency Connect button is not working
● There may be a phone off the hook somewhere in your home.
● Check the Auto On Hook Feature
● The remote band’s battery is low or is not installed properly.
● Check the antenna on base.
TROUBLESHOOTING