Operation, Hazard avoidance, Displaying traffic data – Garmin G1000 Quest Kodiak User Manual
Page 353
190-00590-03 Rev. A
Garmin G1000 Pilot’s Guide for the Quest KODIAK 100
SY
STEM
O
VER
VIEW
FLIGHT
INSTRUMENTS
EIS
AUDIO P
ANEL
& CNS
FLIGHT
MANA
GEMENT
HAZARD
AV
OID
ANCE
AFCS
ADDITIONAL
FEA
TURES
APPENDICES
INDEX
341
HAZARD AVOIDANCE
OPERATION
The unit must be in operating mode for traffic to be displayed. The ability to switch from standby to operating
mode on the ground is especially useful for scanning the airspace around the airport before takeoff.
Switching from standby mode to operating mode:
1)
On the Traffic Page, press the OPERATE Softkey or press the MENU Key and turn the small
FMS
knob
to select
Operating Mode.
2)
If using the FMS menu, press the ENT Key to place the SKY497 in the operating mode.
3)
To switch to Standby Mode from the Traffic Page, press the STANDBY Softkey.
System Self Test
1)
Set the range to 2/6 nm.
2)
Press the STANDBY Softkey.
3)
Press the TEST Softkey.
4)
Self test takes approximately eight seconds to complete. When completed successfully, traffic symbols display
and a voice alert “Traffic Advisory System Test Passed” is heard. If the self test fails, the system reverts to
Standby Mode and a voice alert “Traffic Advisory System Test Failed” is heard.
DISPLAYING TRAFFIC DATA
Traffic information can be displayed on the following maps when the SKY497 unit is operating:
• PFD Inset Map
• Navigation Map Page
• Traffic Map Page
• Trip Planning Page
• Nearest Pages
• Active Flight Plan Page
• AUX - Video Page
Traffic information can also be displayed on the PFD when the Synthetic Vision System (SVS) option is
installed and enabled. See the Additional Features Section for details.
Displaying traffic on the Traffic Map Page:
1)
Turn the large FMS Knob to select the Map Page Group.
2)
Turn the small FMS Knob to select the Traffic Map Page.
3)
Press the OPERATE Softkey to begin displaying traffic. OPERATING is displayed in the Traffic mode field.
4)
Press the ALT MODE Softkey to change the altitude volume.
5)
Press the STANDBY Softkey to place the system in the Standby mode. STANDBY is displayed in the Traffic mode
field.
6)
Turn the RANGE Knob clockwise to display a larger area or counter-clockwise to display a smaller area.