Dell OptiPlex GX240 - Manual (Page 124)

122 I n s t a l l i n g U p g r a d e s
www
.dell.com | support.dell.com
S m a l l M i n i -To w e r C o m p u t e r
2 Check all connectors to be certain that they are properly cabled and
firmly seated.
NOTICE: To avoid possible damage to the computer, you must match the
colored stripe on the hard-drive data cable with pin 1 on the hard drive (IDE1)
connector and with the system board interface connector (IDE1).
To locate the IDE connector 1 (IDE1) on the system board, see
“
System Board Components .”
3 On the small desktop computer, if your computer has a hard-drive
shroud, replace the shroud by inserting the two tabs on the bottom
into the holes in the computer and snapping the top into place.
(Operating the computer without a hard-drive shroud does not affect
its performance.)
1 power cable
2 IDE cable
3 IDE1 connector
3
1
2