Heat sink assembly, Removing the heat sink assembly – Dell XPS 210 User Manual
Page 22
3.
Slide the drive into place until you feel a click or feel the drive securely installed.
4.
Connect the interface cable to the back of the Media Card Reader and to the Media Card Reader connector on the system board (see
System Board
Components
).
5.
Replace the hard drive (see
).
6.
Replace the CD/DVD drive (see
).
7.
Replace the computer cover (see
Replacing the Computer Cover
).
8.
Connect your computer and devices to electrical outlets, and then turn them on.
See the documentation that came with the Media Card Reader for instructions on installing any software required for its operation.
9.
Enter system setup (see
Entering System Setup
) and select the appropriate Drive option.
Heat Sink Assembly
Removing the Heat Sink Assembly
1
drive
2
drive bracket
3
screws (4)
1
interface cable
NOTICE:
To connect a network cable, first plug the cable in to the network port or device, and then plug it in to the computer.
CAUTION:
Before you begin any of the procedures in this section, follow the safety instructions in the Product Information Guide.