Dell PowerEdge C1100 - Manual (Page 21)

Using the Baseboard Management Controller 21
Services
The Services page enables you to view and change the interface. After entering the attribute's
values, click Apply Changes at the bottom of the page.
Web Server
The web server support four simultaneous sessions.
NOTE: To modify these settings, you must have permission to configure iBMC.
SSL Main Menu
Use this page to generate a certificate signing request (CSR), upload a server certificate to the
iBMC firmware, or view an existing server certificate.
NOTE: You must have Configure iBMC permission to generate or upload a server certificate.
Use the Certificate Management page to generate a certificate signing request (CSR) to send to a
certificate authority (CA). The CSR information is stored on the iBMC firmware.
A CSR is a digital request to a CA for a secure server certificate. Secure server certificates ensure
the identity of a remote system and ensure that information exchanged with the remote system
cannot be viewed or changed by others. To ensure the security for your Dell Remote Management
Controller, it is strongly recommended that you generate a CSR, submit the CSR to a CA, and
upload the certificate returned from the CA.
After the CA approves the CSR and sends you a certificate, you must upload the certificate to the
iBMC firmware. The CSR information stored on the iBMC firmware must match the information
contained in the certificate.
Table 1-23. Web Server Settings
Settings Description
Max Sessions Maximum number of simultaneous sessions allowed for this system.
Active Sessions Number of current sessions on the system, less than or equal to the
Max Sessions.
Timeout The time, in seconds, that a connection is allowed to remain idle. The
session is cancelled when the timeout is reached. Changes to the
timeout setting do not affect the current session. When you change
the timeout setting, you must log out and log in again to make the
new setting effective. Timeout range is 60 to 3600 seconds.