EVS XTnano Version 11.01 - November 2012 Configuration Manual - Manual (Page 66)

• The secondary links of the V3X boards correspond to the middle connectors of a
codec module:
◦ J5 for IN connectors (only IN 1B to 3B)
◦ J3 for OUT connectors (only OUT 1B and 2B)
Channel Assignment in 2R/CM Configurations
With V3X boards, the 2R/CM configurations should be cabled in the following sequence:
1. Cable the play channels from left to right.
2. Cable the record channels from right to left starting with the primary links, without
using the left codec modules already cabled as play channels.
3. Cable the remaining record channels to assign starting from right to left, and using the
secondary link for the remaining codec modules.
3.2.2. SD/HD Base Configurations
Introduction
The table below shows the available standard SD/HD configurations with an XTnano
server (with COHX or V3X boards), and how the BNC connectors should be cabled.
The 2R/CM configurations, presented at the end of the table, make use of the secondary
link of the codec module of a record channel as an independent recorder. See also the
section "Channel Assignment in 2R/CM Configurations" on page 56.
The option '2R/CM' is only available with an XTnano server equipped with V3X boards.
XTnano Server - Version 11.01 - Configuration Manual
3. Multicam Configuration 56