EVS ENGSoft v1.5 User Guide - Manual (Page 21)

ENGSoft v1.5
This document is the exclusive property of OpenCube Technologies SAS and cannot be reproduced or distributed without prior authorization
21 / 63
10.3.2 e-VTR source
ENGSoft uses the FTP connection to browse and ingest tapes on e-VTR devices.
As SONY e- VTR devices are accessible via FTP connection and thus are not plug and play devices, the e- VTR source con-
figuration is slightly different from that of other sources.
Figure 29: e-VTR source module
In e-VTR mode, sequences cannot be played back and auto-ingest is not available.
To configure e- VTR, click on the button. The "Configure e- VTR - FTP connection" window appears. You have to fill in
each field:
l Alias: name displayed in the combo box;
l FTP Address: IP address of the e-VTR;
l Port: FTP port of the e-VTR (21 by default);
l Login: login to logon on to the e-VTR (e-VTR by default);
l Password: password to logon on to the e-VTR (e-VTR by default).
Figure 30: e-VTR configuration
Once you have filled in all the fields, you can check the parameters by clicking on the [Test Connection] button.
A status message will be displayed at the left of the [Test Connection] button.
Figure 31: e-VTR configuration connection status
If the connection is successful, click on [OK].