EVS ENGSoft v1.5 User Guide User Manual
Page 44
ENGSoft v1.5
This document is the exclusive property of OpenCube Technologies SAS and cannot be reproduced or distributed without prior authorization
44 / 63
Figure 75: Audio routing panel with a configured mapping
The audio configuration panel is divided in several zones:
l
The top part contains the name of the current audio routing configuration. By default no configuration is set.
l
The middle zone contains up to two
audio layout graphs, each one corresponding to a possible ingest scenario,
four or eight audio. Each layout must be completely connected to make a valid configuration.
l
The bottom zone contains a summary of the status of the current configuration, a "Save" button to save the current
configuration and a "Save as..." button which allows you to choose the name of the configuration to save.
Default audio routing configuration
By default no routing is applied to the destination subject. A straight one to one mapping graph is applied: source pin #1 is
connected to destination pin #1, source pin #2 to destination pin #2, and so on.
Figure 76: Default audio mapping
Audio layout description
There are up to two
audio layout graphs per audio configuration, each one corresponding to a possible ingest scenario:
four or eight audio.