Philips HR7771 - Manual (Page 12)

12
4 Let the appliance run for at least 30 seconds until the food
processor bowl or blender jar is clean.
5 Detach the blender jar or food processor bowl and rinse it with
clean water.
Balloon beater (HR7772)
Always clean the balloon beater immediately after use.
The balloon beater can be cleaned in the dishwasher. You can also pull the
beaters out of the balloon beater to clean them separately.
1 Pull the beaters out of the balloon beater housing. (Fig. 40)
2 To reassemble, push the beaters back into the balloon beater
housing.
Citrus press
Always clean the citrus press immediately after use.
The citrus press can be cleaned in the dishwasher. You can also pull the
cone from the sieve to clean them separately.
1 Pull the cone from the sieve (Fig. 41).
2 To reassemble, push the cone back on the sieve of the citrus press.
storage
1 Push the cord into the cord storage compartment on the back of
the motor unit. (Fig. 42)
Environment
- Do not throw away the appliance with the normal household waste
at the end of its life, but hand it in at an official collection point for
recycling. By doing this, you help to preserve the
environment (Fig. 43).
EnglisH 12
guarantee & service
If you need service or information or if you have a problem, please visit
the Philips website at www.philips.com or contact the Philips Consumer
Care Centre in your country (you find its phone number in the
worldwide guarantee leaflet). If there is no Consumer Care Centre in
your country, go to your local Philips dealer.
troubleshooting
This chapter summarises the most common problems you could
encounter with the appliance. If you are unable to solve the problem with
the information below, contact the Consumer Care Centre in your
country.
Problem Solution
When I select a
speed or press the
pulse/Easy Clean
button, appliance
does not start to
operate.
Make sure the food processor or blender jar and
its lid are assembled correctly (‘click’).Make sure
that the tool holder has been inserted properly if
you are using any accessory with the food
processor bowl. If you use the blender jar, make
sure that the handle of the blender points to one
of the four corners of the motor unit. Keep the
lid fixed to avoid spillage. If you use the food
processor, make sure that the bowl handle is
directly above the closed lock symbol. The bowl
lid is correctly assembled when the projection is
locked into the slot of the bowl handle. If all parts
are assembled correctly, the appliance starts to
operate when you select a speed with the speed
selector or press the pulse/Easy Clean button.
The
appliance suddenly
stops running.
The thermal safety cut-out has probably cut off
the power supply to the appliance because the
appliance has overheated. 1) Unplug the
appliance. 2) Let the appliance cool down for 1
hour. 3) Put the mains plug in the socket. 4)
Switch on the appliance again.