MSD 8886 Adapter Cable for MSD 6010_60101 to GM OEM Sensors Installation User Manual
Page 2
INSTALLATION INSTRUCTIONS
M S D I G N I T I O N
• w w w . m s d i g n i t i o n . c o m • ( 9 1 5 ) 8 5 7 - 5 2 0 0 • FA X ( 9 1 5 ) 8 5 7 - 3 3 4 4
MAP sensor
Disconnect the MAP sensor harness and install the MSD Harness inline. The Gray Connector of the
Harness goes to the MAP sensor. Connect the MAP connector of the 6LS into the connector with a
single signal wire (Figure 2).
CAMshAft sensor
Locate the Camshaft Sensor. On LS-1/LS-6 based engines, the Cam Sensor is in the rear of the block
where the distributor would generally be (Figure 3). On LS-2 based engines, the Cam Sensor is on
the front of the block. Note that on LS-2 based engines, Cam Sensor Extension Harness, PN 88861
is required.
Disconnect the factory sensor and install the MSD Harness (Black connector) inline. Connect the
Cam Connector of the 6LS to the connector with a single signal wire.
Figure 2 Map Sensor Connection.
Figure 3 Camshaft Sensor Location.
FACTORY HARNESS
PN 8886
HARNESS
MAP
SENSOR
REAR OF BLOCK
CAM
SENSOR
LS-1 SERIES
LS-2 SERIES
CAM
SENSOR
TIMING
COVER
TO MSD
6LS
REAR OF INTAKE
NOTE:
REQUIRES
EXTENSION
HARNESS
PN 88861