MSD 8886 Adapter Cable for MSD 6010_60101 to GM OEM Sensors Installation - Manual (Page 3)

INSTALLATION INSTRUCTIONS 
M S D I G N I T I O N
• w w w . m s d i g n i t i o n . c o m • ( 9 1 5 ) 8 5 7 - 5 2 0 0 • FA X ( 9 1 5 ) 8 5 7 - 3 3 4 4
CrAnkshAft sensor
This sensor is located just above/behind the
starter. If the engine is in the car, you will need
to assemble the supplied special tool to access
the sensor connector (Figure 4), or remove the
starter. If the engine is out of the car the sensor
should be easy to reach.
Disconnect the crank sensor and install the
MSD Harness with three wires to the factory
connectors. Connect the single wire connector
to the Crank Sensor connector of the 6LS
Control.
CrAnkshAft ConneCtor
sPeCiAl tool
This tool will help you access the crankshaft
sensor from behind the starter
when the engine is in the
vehicle.
Assemble the Tool as shown in
Figure 5.
1. Insert the tool through the
casting hole with the bend in
the blade facing the rear of the car.
2. Rotate the tool clockwise about 10-degrees and push the tool further through the casting hole.
3. Rotate the tool clockwise until the blade meets the Connector tab. At this point, push the tool
towards the rear of the car in order to disconnect the crank sensor.
4. Use the tool to connect the 3-pin MSD harness connector to the sensor (Figure 6).
5. Connect the factory sensor connector to the MSD harness.
6. Connect the single wire harness to the matching 6LS connector.
Figure 4 Crankshaft Sensor Location.
Figure 5 Assembling the Special Tool.
CRANK
SENSOR
STARTER
SOLENOID
Figure 6 Connecting the Crank Sensor.