Prestart check list, Installation instructions 5 m s d – MSD 6530 Digital Programmable 6AL-2 Installation User Manual
Page 5
INSTALLATION INSTRUCTIONS
5
M S D
• W W W . M S D P E R F O R M A N C E . C O M • ( 9 1 5 ) 8 5 7 - 5 2 0 0 • F A X ( 9 1 5 ) 8 5 7 - 3 3 4 4
PRESTART CHECK LIST
• The only wires connected to the coil terminals are the MSD Orange to coil positive and Black to
coil negative.
• The small Red wire of the MSD is connected to a switched 12 volt source.
• The MSD power leads are connected directly to the battery positive and negative terminals.
• The battery is connected and fully charged if not using an alternator.
• The engine is equipped with at least one ground strap to the chassis.
• If running a 4 or 6-cylinder, the cylinder count must be modified in the Pro-Data+ Software. Default
is 8-cylinder.
LED
The LED on the side of the MSD monitors several operating conditions of the MSD. If the LED indicates
that there is a problem with the ignition system, follow the steps through the Troubleshooting section.
The LED will appear to be on steady at above idle speeds when everything is functioning properly.
• When 12 volts are applied to the small Red wire, the LED will turn on to indicate power.
• When cranking or running, the LED will blink for each trigger signal.
• Code 2 will flash for low battery voltage.
• Code 3 will flash for high battery voltage.
• Code 4 will flash for converter off (ignition problem).
WARNING: The MSD 6-Series Ignitions are capacitive discharge ignitions. High voltage is present
at the coil primary terminals. Do not touch the coil or connect test equipment to the
terminals.
Figure 2 Wiring the Programmable 6AL-2 Ignition with a Magnetic Pickup.
GREEN
PN 8860
HARNESS
VIOLET
OR
GREEN
VIOLET
DISTRIBUTOR
WITH
MAGNETIC PICKUP
MSD CRANK
TRIGGER WHEEL
DISTRIBUTOR
+
HEAVY RED
HEAVY BLACK
TO BATTERY
TO BATTERY
+
ORANGE (TO COIL +)
BLACK (TO COIL -)
WHITE
AMPLIFIER/POINTS
(NOT USED)
IGNITION KEY
TO 12V
RED
PINK
DARK BLUE
LIGHT BLUE
WHITE/BLUE
HALL-EFFECT
(NOT USED)
LAUNCH
(12V TO ACTIVATE)
BURNOUT
(12V TO ACTIVATE)
RETARD
(12V TO ACTIVATE)
GRAY
TACH OUTPUT
MAP
SENSOR
RED