MSD 6305 SC Coil Driver Ignition for MSD SC Distributors Installation - Manual

MSD SC Coil Driver
PN 6305
IMPORTANT: Read the instructions before attempting the installation.
Parts Included:
1 - SC Coil Driver, PN 6305
1 - Parts Bag and Mounting Hardware
WARNING: During installation, disconnect the battery cables. When disconnecting the battery,
always remove the Negative cable first and install it last.
WARNING: The Blaster SC Coil and Coil Driver produce very high voltage and current. Use
caution during installation and while working near the Coil assembly.
The MSD SC Coil Driver is designed to be used with the Blaster SC Coil, PN 8235, and Pro-Billet
Honda Distributor, PN 8488. An MSD SCI, 6-Series and 7-Series Ignition Control may also be used
(The SC Coil Driver cannot be used with the MSD Blaster SS Coil, PN 8207).
CoIl loCatIon and MountIng
1. Find a suitable mounting location for the Coil
and Driver assembly. It can be mounted in any
position as long as it is away from direct engine
heat sources. Also make sure that the Coil Driver
wiring harness reaches the distributor.
2. Ensure that there is enough room to clear the Coil
and the Coil Driver when they are assembled.
3. Use the Coil or Driver as a template and mark
the mounting holes. Figure 1 also provides a
template to assist in the mounting.
4. Use a 3/16" drill bit to make the mounting
holes.
Components Required:
1 - Blaster SC Coil, PN 8235
1 - Pro-Billet Honda Distributor, PN 8488
Figure 1 Coil Driver Mounting Template.
M S D I G N I T I O N
• w w w . m s d i g n i t i o n . c o m • ( 9 1 5 ) 8 5 7 - 5 2 0 0 • FA X ( 9 1 5 ) 8 5 7 - 3 3 4 4