MSD 6305 SC Coil Driver Ignition for MSD SC Distributors Installation - Manual (Page 2)

 INSTALLATION INSTRUCTIONS
M S D I G N I T I O N
• w w w . m s d i g n i t i o n . c o m • ( 9 1 5 ) 8 5 7 - 5 2 0 0 • FA X ( 9 1 5 ) 8 5 7 - 3 3 4 4
Figure 2 Assemble the Coil and Driver.
Figure 3 Wiring the Coil and Driver to the Distributor.
asseMble the CoIl and dRIveR
1. Position the Coil Driver, PN 6305, under the
Blaster SC Coil with the aluminum base facing
down (Figure 2).
2. Install the long Phillips screws through the coil
and into the supplied vibration mount at the
base of the Coil Driver.
3. Mount the Coil/Driver assembly.
WIRIng
Primary Wires: The two primary wires, Red and
Orange, are the only wires that connect to the
coil. Orange connects to Coil Negative (-), Red
connects to the Coil Positive (+) terminal. Install
a lock washer followed by the wire terminal with
another lock washer and the supplied Phillips
screws.
Distributor Connector: Route the 4-pin Deutsch
Connector to the mating connector on the
distributor (Figure 3).
Tachometer Output: The Blue wire that is routed
with the distributor connector provides a 12 volt
square wave tachometer output signal. It can be
used for aftermarket tachs, rpm switches and
other accessories (Figure 3).
Note: Vehicles equipped with OEM tachometers
do not require any special wiring for the tach
to operate.