Ohaus TROOPER COMPACT SCALES Manual multi - Manual (Page 12)

EN-6
Trooper Scale
2.3.3 Leveling the Scale
Exact horizontal positioning and stable installation are prerequisites for repeatable results. To compensate small
irregularities or inclinations at the location, the instrument can be leveled.
For exact horizontal positioning, the Scale is equipped with a level indicator located at the rear.
Adjust the leveling feet until the air bubble in the indicator is centered.
NOTE: The instrument should be leveled each time its location is changed.
2.3.4 Stabilization
Before initially using the Scale, allow time for it to adjust to its new environment. Recommended warm up period is
five (5) minutes.
3. OPERATION
The Trooper Scale has been factory calibrated and is ready for operation. You can operate the scale at this point using
the factory default settings. You can check the default menu settings on page 11. All bolded items on the menu are the
factory default settings. The scale will operate in the default mode. If you want to change the settings, continue with
Section 4, Setup.
When the Scale is positioned for operation, follow the operational procedure outlined next.
2. INSTALLATION (Cont.)