Ohaus TROOPER COMPACT SCALES Manual multi - Manual (Page 26)

EN-20
Trooper Scale
INTERVAL - PRINTING (Cont.)
Pressing the TARE button increments the digit from 1 to
0. When the desired number of seconds have been en-
tered, press the G/N/T/
MENU button. Stb OFF is displayed.
STABLE
When set ON, allows only stable weight values to be printed.
When set OFF, prints immediate value with an indication of
stability. In LFT, fixed to ON.
With Stb OFF displayed, press PRINT/ UNITS button, and
select ON or OFF. Default setting is OFF.
SAVE
Press G/N/T/ MENU button to end this block, SAVE is dis-
played. All settings are retained.
Press G/N/T/ MENU button to save settings, LOCSW is
displayed which is the next menu or press PRINT/ UNITS
button to go back to Read menu without saving.
NOTE: (If initial setup, go to the next paragraph. To exit
from the Setup, press PRINT/
UNITS button to skip to
LOCKSW, then QUIT. Press G/N/T/ MENU button to go back
to the weighing mode).
4.4.5 Print Menu
4.4.6 Lockout Switch Menu
Lockout Switch menu (LOCSW) is a software controlled option which can lock the settings in the Calibration, Setup,
Readout, and Print menus to prevent tampering. When used in conjunction with the Lock Switch on the printed circuit
board, the Calibration, Setup, Readout and Print menus can be read only and not changed by an operator or the switch
can be left in place and the LOCSW menu is used to prevent accidental changes..
Procedure
To select any of the items in the Lockswitch menu, proceed
as follows: NOTE: If you have entered from the preceeding
menu, disregard the first step.