Ohaus EXPLORER PRECISION HIGH CAPACITY BALANCES Manual - Manual (Page 10)

EN-8 EXPLORER BALANCES
2.2.5 Installing the Draft Shield Glass and Doors on Draft Shield Models
1. Carefully remove each of the four glass Draft Shield sections from the packaging.
NOTE: Before installing side doors, be sure to set the lock tabs in the proper position, as shown here.
UNLOCK: LOCK:
2. Follow the steps below to install side, front and top doors of the Draft Shield.
Side Door Installation
1. Unlock 2. Align
3. Clear 4. Lock
Position glass door to slide. Open lock tab (top); insert in top groove and slide inside bottom groove.
Close lock tab.
Front Panel Installation
1. Release
terminal
2. Align
3. Push to
rear
4. Reconnec
t terminal
Press button to separate Terminal from Base. Seat pan
el’s hooked ends in base. Swing panel to
vertical position.
Top Door Installation
1. Align 2. Press Down
Insert Top Door’s hooked ends in grooved pegs. Press gently to seat. Check for smooth movement. Close door.