Ohaus EXPLORER PRECISION HIGH CAPACITY BALANCES Manual - Manual (Page 149)

EXPLORER BALANCES EN-147
Balance Setup for USB Interface
A) The Ohaus Interface is preset to communicate using the following settings:
9600 baud, 8 bit, no parity, no handshake, 1 stop bit.
This is a fixed setting and cannot be changed.
B) Configure the balance to the desired USB and printing parameters.
PRINT
Stable
On, Off
A-Print
Cont, On.Stbl, On.Acc*, 5sec, 15sec, 30sec,
60sec, off
End
Yes, No
*Note: Print and USB menu selections may
vary between the different balance series.
USB
USB
On / Off
Baud
600, 1200, 2400, 4800, 9600, 19200
Parity
7-even, 7-odd, 7-none, 8-none
Handshake
None, Xon-Xoff, RTS-CTS
END
Yes, No
SETUP DEFINITIONS
PRINT / Stable – On Balance transmits stable data only.
PRINT / Auto Print – Continuous Balance repeatedly sends data as fast as possible.
PRINT / Auto Print – On Stable Balance automatically outputs data upon stability.
PRINT / Auto Print – (xx) sec Balance sends data every (xx) seconds.
PRINT / Auto Print – Off Only sends data when PRINT is pressed.
USB / USB – Off Turns Interface off, saving battery power.
USB / Baud, Parity, Handshake Set parameters to match printer or computer.
Operation
USB OUTPUT
With the Adapter installed the balance will operate in one of the following three ways:

USB = On, Auto Print = Off, Stable = On or Off
Press PRINT to send the display data based on the settings in the Menu.
If Stable is set to On, the balance will wait for a stable reading before sending data.

USB = On, Auto Print = On, Stable = On or Off
The balance will automatically send data.
If Stable is set to On, only stable values will be sent.

USB = Off
The interface is turned off.