Shogun Motorsports Honda CBR600RR (07-08) NO CUT Frame Slider - Manual (Page 3)

6.
Mount the right side offset using the stock OEM 12mm Hex Flange bolt. Make sure that the wire
loom is routed properly and not being pinched by the offset in anyway. Line up the edge of the
offset (wile mounted) with the edge of the frame and torque down.
7.
Use one drop of blue thread locker on the (99-HB-SH10125070) Socket Cap 10 X 1.25 X 70 (Holds
puck to offset). Torque down to 30 to 32 foot lbs.
8.
Remount lower panel.
READ CAREFULLY
Shogun cannot guarantee that they will protect your motorcycle from any extent of damage.
Shogun frame sliders are really meant to help possibly save the frame from damage in the
event of a crash. Because Shogun frame slider products have been very successful in saving
cases, bodywork, levers and so on in the past, customers just assume sometimes you can put
the product on and no damage will happen. The fact is, some crashes result in little or no
damage to the motorcycle and some bikes are destroyed. It’s kind of like a bumper on a car
sometimes it works sometimes it doesn’t, it really depends on all the different forces applied
during the incident. We’ve seen bikes crash at 100 mph with little damage and some at 15
mph with major damage.