Shogun Motorsports Kawasaki Ninja 300R DMP Fender Eliminator Instructions - Manual

Moto911 Inc. - 1062 Calle Negocio, Ste. J, San Clemente, Ca. 92673 – (949)453-9111
Kit Contents
Part Number Description Quantity Part Number Description Quantity
99-FE-670-4210 Fender Brackets 2 99-Wash6x12 6x12mm Washer 2
99-Wash6x15 6x15mm Washer 10 99-HB-6x12 6x12 Bolt 2
99-LN-6 6mm Locknut 6 99-HB-6x16 6x16 Bolt 4
Note: To complete your installation we recommend using DMP Marker Lights and DMP OEM Type
Wire Harness, which are available from your local DMP dealer or
www.moto911.com . Make sure bike
is turned off during installation. It is highly recommended that the DMP fender Eliminator and marker
lights are installed by a certified technician. DMP is not responsible for any part of your motorcycle for
any reason. If in any doubt please call us during installation.
1. Remove rear seat.
2. Remove the two body work bolts located in front of the tail light
3. Remove side bolts
4. Remove body work rivets
Kawasaki Ninja 300R 2013
Fender Eliminator Kit
P/N: 670-4210
MADE IN THE USA!