Shogun Motorsports Kawasaki Ninja 300R DMP Fender Eliminator Instructions User Manual
Page 6
Advertising
Moto911 Inc. - 1062 Calle Negocio, Ste. J, San Clemente, Ca. 92673
– (949)453-9111
19. Using the larger 6mm washer and 6x16mm bolt insert into the open hole. On the inside of the
tail section slide the larger 6mm washer over the bolt and screw on the 6mm lock nut. Using a
socket wrench on one side and an allen wrench on the other torque down the bolts. Do not
over tighten, the lock nuts have nylon to keep from coming loose.
20. Pull slack from wires through the tail section and snap the OEM cap that was removed earlier
back into place
21. Install DMP OEM marker light connectors.
Advertising